Always mention the above model number when com mu ni -
cat ing with us regarding battery pack.
Use battery pack for Ryobi Cordless products only. Refer to
the Operator’s Manual provided with product.
This battery pack requires 1 hour of charging time to be
fully charged.

SAFETY RULES

Ryobi P731 Manuals & User Guides. User Manuals, Guides and Specifications for your Ryobi P731 Automobile Accessories, Battery Charger. Database contains 2 Ryobi P731 Manuals (available for free online viewing or downloading in PDF): Operator's manual, Product fact sheet. Your charger has been engineered and manufactured to our high standard for dependability, ease of operation, and operator safety. When properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual before using this product.

n

Recommended chargers:

MODEL

CHARGER (P110)

P100

1423701 or 140237021

n

For best results, your battery should be charged in a
location where the temperature is more than 50°F but
less than 100°F. Do not store outside or in vehicles.

n

Under extreme usage or temperature conditions, bat-
tery leakage may occur. If liquid comes in contact with
your skin, wash immediately with soap and water, then
neutralize with lemon juice or vinegar. If liquid gets
into your eyes, flush them with clean water for at least
10 minutes, then seek immediate medical attention.
Following this rule will reduce the risk of serious personal
injury.

n

Save these instructions. Refer to them frequently
and use them to instruct others who may use this
tool. If you loan someone this tool, loan them these
instructions also to prevent misuse of the product and
possible injury.

WARNING!

READ AND UNDERSTAND ALL IN STRUC TIONS. Fail-
ure to fol low all instructions listed below, may result in
elec tric shock, fire and/or serious per son al in ju ry.

n

When battery pack is not in use, keep it away from oth-

er metal objects like: paper clips, coins, keys, nails,

screws, or other small metal objects that can make

a connection from one terminal to another. Shorting

the battery terminals together may cause sparks, burns,

or a fire.

n

Do not place battery tools or their batteries near fire
or heat. This will reduce the risk of explosion and possibly
injury.

n

Never use a battery that has been dropped or
received a sharp blow. A damaged battery is subject to
explosion. Properly dispose of a dropped or damaged
battery immediately.

n

Batteries vent hydrogen gas and can explode in the
presence of a source of ignition, such as a pilot light.
To reduce the risk of serious personal injury, never use
any cordless product in the presence of open flame. An
exploded battery can propel debris and chemicals. If
exposed, flush with water immediately.

n

Do not charge battery in a damp or wet
location. Following this rule will reduce the risk of electric
shock.

18 VOLT
BATTERY
PACK

P100

CHARGERS
SOLD SEPARATELY

OPERATION

CHARGING THE BATTERY PACK

Battery packs are shipped in a low charge condition to prevent
possible problems. Therefore, you should charge them until
the green LED on the front of the charger comes on.
NOTE: Batteries will not reach full charge the first time they
are charged. Allow several cycles (operation followed by
recharging) for them to become fully charged.

User Manual Pdf

CHARGING A COOL BATTERY PACK

If battery pack is within normal temperature range, the red
LED on charger will come on.
NOTE: If the charger does not charge the battery pack
under normal circumstances, return both the battery pack
and charger to your nearest Ryobi Authorized Service Cen ter
for electrical check.
n

Ryobi P110 Charger Manual

Charge the battery pack only with a recommended
charger.

n

Make sure the power supply is normal household

voltage,

Ryobi Owner's Manual

120 volts, 60 Hz, AC only.

n

Connect the charger to the power supply.

n

Place the battery pack in the charger aligning raised rib

on the battery pack with the groove in the charger. See
Figure 1.

n

Press down on the battery pack to be sure contacts on

the battery pack engage properly with contacts in the

charger.

n

Normally the red LED on charger will come on. This

indicates the charger is in fast charging mode.

n

Red LED should remain on for approximately 1 hour

then the green LED will come on. Green LED on

indicates battery pack is fully charged and charger is

in maintenance charge mode.

12

Fig. 4

P110

CHARGER

YELLOW LED

RED LED

Fig. 5

P110

CHARGER

Ryobi P110 18v Battery Charger

BATTERY

PACK

GREEN LED

CHARGING A HOT BATTERY PACK

When using the tool continuously, the batteries in the battery

pack will become hot. You should let a hot battery pack cool

down for approximately 30 minutes before attempting to

recharge. When the battery pack becomes discharged and

is hot, this will cause the green LED to come on instead of

the red LED. After 30 minutes, reinsert the battery pack in

the charger. If the green LED continues to remain on, return

battery pack to your nearest Ryobi Authorized Service Center

for checking or replacing.
NOTE: This situation only occurs when continuous use of

the tool causes the batteries to become hot. It does not

occur under normal circumstances. Refer to

“CHARGING

A COOL BATTERY PACK” for normal recharging of batter-

ies. If the charger does not charge your battery pack under

normal circumstances, return both the battery pack and

charger to your nearest Ryobi Authorized Service Center

for electrical check.

INSTALLING THE BATTERY PACK

See Figure 6.
n

Lock the switch trigger by releasing it all the way.

n

Place the battery pack on the tool.

n

Make sure the latches on each side of the battery pack

snap into place and the battery pack is secured on the
tool before beginning operation.

CAUTION:

When placing the battery pack on the tool, make sure
that the raised rib inside the tool aligns with the groove
on the battery pack and that the latches snap into place
properly. Improper assembly of the battery pack can
cause damage to internal components.

REMOVING THE BATTERY PACK

See Figure 6.
n

Lock the switch trigger by releasing it all the way.

n

Ryobi P110 Charger Lithium

Depress the latches on the side of battery pack.

n

Remove the battery pack from the tool.

OPERATION

User Manual For Iphone

BATTERY PACK

LATCHES

DEPRESS LATCHES TO

RELEASE BATTERY PACK

Fig. 6

BATTERY SHOWN ATTACHED TO CHARGER